Motec GPS-L10 User Manual download pdf (Page 4)

2 Using the GPS

Electrical Connections

The GPS unit sends data to the logging device via an RS232 serial

connection.

The wiring between the GPS connector and the logging device should be as

short as possible, preferably less than 1 m (3 ft).

The following table shows how to wire the GPS unit to a number of MoTeC

logging devices.

GPS

Name

Logging

Device

Name

ADL3

SDL3

ACL

M84/M400/M600/

M800/M880 ECU

Bat -

Bat- from

VIM/SVIM

Not

Used

etc

Requires 5V

from

VIM/SVIM

Note that the ADL3 and SDL3 logging devices only have one serial

connection therefore if an ECU is to be connected then it must be connected

via CAN. (Note that not all ECUs have a CAN connection)

GPS Configuration

The GPS-L10 comes preconfigured from MoTeC to suit MoTeC data loggers.

The GPS-L5 comes preconfigured to suit MoTeC’s ‘Hundred Series’ and M84

ECUs.

1 2 3 4 5 6 7 8

No comments

Motec GPS-L10 User Manual Page 4