Motec PDM30 User Manual download pdf (Page 32)

MoTeC Operation 29

Password Protection

 On the Online menu, click Set Password

The password will prevent unauthorised retrieving and sending of

configuration files.

It is not possible to update firmware if the PDM is password protected.

Standby Mode

The PDM has a low power standby mode to minimize battery drain when the

vehicle is turned off.

Up to four outputs can be configured in the Output Pin settings to stay alive

(i.e. remain turned on) during the standby mode. These outputs are intended

for powering applications where electronic devices require a continuous low

current (typically micro amps) supply to maintain settings or state.

The PDM enters the low current Standby Mode when all of the following

conditions have been true for 5 minutes:

- All outputs that do not have the “stay alive during standby mode” option

enabled are turned off

- All outputs that have the “stay alive during standby mode” option enabled

are below the allowed current limits (approximately 0.5A)

- No CAN messages have been received

- No CAN messages have been successfully transmitted

The PDM will exit the Standby Mode when any of the following conditions are

true:

- Activity is present on the CAN bus

- Any output that has the “stay alive during standby mode” option enabled

exceeds the allowed current limit (approximately 0.5A)

- Any input pin changes state

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 60 61

No comments

Motec PDM30 User Manual Page 32