Motec PDM30 User Manual download pdf (Page 19)

16 Configuration

To rename a channel globally

 Right-click on the channel name in the Channels window and click

Rename.

This will rename the channel where it is generated as well as in all the

places where it is used.

Configuration Tree

The Configuration Tree is used to configure the Global Setup, Input Pins,

CAN Inputs, Conditions, CAN Outputs, Keypad buttons and Output Pins.

The input and output pins will be numbered according to the PDM type

selected.

Global Setup

The Global Setup in the configuration tree is used to

 Enter the PDM type and serial number

 Configure the CAN addresses and timeout periods for incoming CAN

messages

 Configure Master Retry and Master Shutdown channels for output pins

 Configure Keypad settings for CAN keypads

PDM Type and Serial Number

The PDM type (PDM32, PDM16 etc.) and serial number must be configured

correctly before a new configuration file can be sent to a PDM.

A configuration can only be sent to the matching PDM to ensure the correct

configuration of PDMs in applications with multiple PDMs.

Output Pins Master Retry

The Master Retry feature turns all outputs that are in error back on. If there is

still a fault on a particular output, this output will go into error again and will go

through the normal retry sequence.

To initiate a Master Retry by pressing a button

 Wire a button to a switch input

 Use the channel generated by this input as the trigger channel for the

Master Retry.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 60 61

No comments

Motec PDM30 User Manual Page 19